Repair Golf Cart - Tips

One special warning: the growth of the counterfeit parts industry is causing fits for retailers and consumers. If you suspect that you have purchased a bogus part, return it to the retailer for a full return. One more good reason to learn what a company's return policy is before you do business with them.



Many times I do hunt for my Mercedes car parts in the Mercedes junkyard parts and I have not been disappointed at all. Instead of having to dig deep in my wallet, I bag a bargain in this sort of places. The point is that, there are certain car parts that never go out of fashion.

Performing a checkup on your coolant system is one of the easier things you'll do. A word of warning. Only do the checkup when the system is cool. A hot system is under pressure and you really do not want to end up in the hospital due to coolant burns. Hot bad. Cold good. Enough said.

Whatever your preference, bow mount or transom mount, be sure to have a fish finder in close view. It is essential to be able to see the structure you are fishing, as you are moving along with your electric motor... it's actually a must!

Locate the oil filler cap on the valve cover. I've seen newbies pour motor oil in everything from the master brake cylinder to the radiator cap. Make sure you have located the the oil filler cap. Remove the oil filler cap.

Before you do anything else, even jetting your bike, if your top-end hasn't been checked or rebuilt in more than 20 hours, get on it! A fresh top-end is preventative maintenance, and it can bring back a couple ponies that you need to pass a rider.

The best motor for a DIY wind generator is one that produces the HIGHEST amount of voltage at the LOWEST possible RPM's. That's a little abstract, so I'll give you some figures. A good motor will produce at least one volt for every 25 RPM's. Where do these numbers come from? They are based on the fact that you will most likely be using your turbine to charge up 12-volt batteries, and to do that, you'll need to be producing, on paper, between 16 and 20 volts.

Continue by measuring the bolt sizes themselves. Take a bolt off and measure the diameter of the head, then the length and diameter of the thread. You may find the right bolt pattern, but the bolt doesn't fit!

salvage yard san antonio texas Now, you are going to need a little help. Even though the truck bed is not extremely heavy, it is recommended to have a minimum of four people to help lift it off. Make sure you set it on wooden blocks to prevent damage in case you decide to sell it or put it back on the truck later.

Every state and town has at least a salvage yard where useful parts of dilapidated vehicles are salvaged for re-use. Most of the parts would be non-functional. But even the most dilapidated vehicles have a usable part either on the inside or on the outside.